Hang Wreath On Stucco Wall Over Plywood

Stucco is a surprisingly hard surface and fastening anything to it can be a huge hassle if you are not properly prepared.

Hang wreath on stucco wall over plywood.

Drill through the center of each traced hole with the masonry bit. First of all use galvanized hardware nails screws etc. Fasten this loop around the upside down hook on your door and pull the string up and over the door onto the exterior side. I show what tools needed and h.

Use a plastic anchor something that will spread out when. Mix your final coat using 1 part cement and 1 to 3 parts sand. You ll need to hold the object you wish to hang tight against the stucco for about 10 seconds to allow the tape to grip onto the ridges of the stucco. Tap it flush with the wall using a rubber mallet if it doesn t go in easily.

Cement plaster stucco as an exterior finish over plywood wall sheathing is recognized as a generic construction sys tem under provisions in the international building code ibc. This bit will drill through the stucco about 7 8 inch thick easily but may slow when it hits the sheathing or a wall stud behind the sheathing. Using clear rope twine or string make a loop on one end. Drill about 1 8 inch deeper than the installation depth of the anchor.

The coating on the hardware will not rust and leave a rust mark on the stucco. Wire lath is affixed to the substrate with. Then gently remove the pressure against the object. A lot of questions that come to mind include things like can i screw into stucco and if so what kind of screws should i use and other related questions.

Add water until your stucco hangs off the trowel. Push a cement wall anchor into each hole. It specifies 7 8 inch exterior cement plaster over wood structural panel wall sheathing with 2x wood studs spaced 16 inches on center. Apply the stucco to create a 1 8 inch thick top coat.

How to hang a wreath on a house with vinyl siding here are some tips on how to hang a wreath on vinyl siding or stucco dryvit. The contractor says he will remove the battens and put a waterproof membrane over the plywood siding then apply three coats of stucco on top of the wire.